<<< List of DRAW commands >>> ============================= Commands are shown in upper case characters, though they are case insensitive. Parameters of commands are shown in lower case, "n, m ..." are integer parameters and "x, y, ..." are floating ones. ---------------------------------------------------------------------------- Command Functionality ---------------------------------------------------------------------------- ANTI Anti-counter full view. BAD Mask bad channels. BEF Display previous event. 2BEF Display two events before. 3BEF Display three events before. CAB Show cable number of given point. Give a point by mouse. CT t1 t2 ic color timing range between t1 and t2 using color index ic CUR Display current event after BEF command. CUT qmin Set pulse height threshold. N command following CUT selecte events. DCT t1 t2 Divide timing range between t1 and t2 into 5 bins and apply default color table (will override previously chosen color ranges) DUMP (n) dump display to file "draw_dump.ps". argument 1 dumps histograms as well. all events in one session will be accumulated there! Thus the ps FILE will NOT be CLOSED before the end of the session. EV n m Go to the event of given run number (n) and event number (m). MA Manual fit. Give exit and entrance points by mouse. MAW Manual fit (Entrace is on the water surface). MAXQ x Set circle size of the maxinum p.e. to x cm. MC Move center. Give edge position by mouse. MUO Muon fit giving exit position. N Next event. NBAD Do not mask bad channel. NCUT disable pulse height cut. (<--> CUT) NEIB Show neighbor PMTs of given point. Give the point by mouse. POn (PO n) Pick up point of ring number "n". PO-n (PO- n) Delete points of ring number "n". PR (n) Print display. argument 1 prints histograms as well. QTH x Set Q threshold to "x" p.e. RCT reset color table RE Redraw screen. RH reset the histograms SAVE Save the current event to the output file. SCAB n Show cable point of given cable number (n) . SER n Go to the event of serial number "n". SF Show fitting result. SK n Skip "n" events. SKIP Interactive skip. SP Spherical display. Sub-commands in spherical mode are ZM n ----- Zoom in (n>0) or zoom out (n<0), where "n" is distance in unit of cm. TG ----- Change exit position. Give the position by mouse. RT ----- Return to usual display mode. STOP,EXIT,QUIT stop display program TCOL Show timing information by colour. TOF is subtracted. WATL z Set water surface level to z cm. ZOOM x Zoom in (x>1) or zoom out (x<1). If x=0.0, original scale. ZQ q1 q2 Zoom the charge histogram (display range from q1 to q2) ZT t1 t2 Zoom the timing histogram (display range from t1 to t2)